White-rodgers 775 User Manual

Browse online or download User Manual for Conditioners White-rodgers 775. White Rodgers 775 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Installation Instructions for
Heating & Air Conditioning
MODEL 775
7 Day Programmable Thermostat
CONTENTS
Preparations .................................................. 1
Thermostat Details ........................................ 1
Removing Old Thermostat ............................ 1
Mounting and Wiring ..................................... 2
Check Thermostat Operation ........................ 3
Programming your Thermostat ..................... 4
Specifications ................................................ 6
Troubleshooting ............................................ 6
PREPARATIONS
THERMOSTAT DETAILS
REMOVING OLD THERMOSTAT
Before removing wires from old thermostat’s switching subbase,
label each wire with the terminal designation it was removed from.
1. Remove Old Thermostat: A standard heat/cool thermostat
consists of three basic parts:
a. The cover, which may be either a snap-on or hinge type.
b. The base, which is removed by loosening all captive screws.
c. The switching subbase, which is removed by unscrewing
the mounting screws that hold it on the wall or adaptor plate.
2. Shut off electricity at the main fuse box until installation is
complete. Ensure that electrical power is disconnected.
3. Remove the front cover of the old thermostat. With wires still
attached, remove wall plate from the wall. If the old thermostat
has a wall mounting plate, remove the thermostat and the wall
mounting plate as an assembly.
4. Identify each wire attached to the old thermostat using the
labels enclosed with the new thermostat.
5. Disconnect the wires from the old thermostat one at a time. DO
NOT LET WIRES FALL BACK INTO THE WALL.
6. Install new thermostat using the following procedures.
To prevent electrical shock and/or equipment damage,
disconnect electrical power to the system at the main
fuse or circuit breaker until installation is complete.
CAUTION
!
Printed in U.S.A.
PART NO. 37-6384A
0212
WHITE-RODGERS
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MISSOURI 63123-5398
www.white-rodgers.com
Failure to follow and read all instructions carefully
before installing or operating this control could cause
personal injury and/or property damage
Assemble tools required as shown below.
YOUR THERMOSTAT REPLACES
1
2
3
WIRE CUTTER/STRIPPER
Typical System Compatibility Chart 620
Standard Heat Only Two Wire Gas or Oil Fired Systems (24 volt) Yes
Electronic Ignition Heat Only Two Wire Systems (24 volt) Yes
Electronic Ignition Heat Only Gas or Oil Fired Systems (24 volt) Yes
Standard Heat/Cool Systems (24 volt) Yes
Heat/Cool Systems Electric Heat (24 volt) Yes
Heat Only Electric Heat Systems (24 volt) Yes
Cool Only Systems (24 volt) Yes
Heat Pump Systems (No Aux or Emergency Heat) Yes
Hot Water Zone Heat Only (Two Wire) Systems Yes
Hot Water Zone Heat Only (Three Wire) Systems No
Line Voltage Heating or Baseboard 110/240 Volt Systems No
Millivolt Systems Floor or Wall Furnaces Yes
12 VDC Mobile Home Application Yes
Multistage Systems No
Systems Exceding 30VAC, 1.5 Amp No
W
RH
B RC
G
O
Y
+
-
+
-
GAS
ELEC
W904
W905
Figure 1. Thermostat base
Mounting
hole
Mounting
hole
W905
Clip for
Hydronic
System
W904
Clip for
Celsius Display
Electric/Gas
Switch
HAND OR POWER
DRILL WITH 3/16 INCH
DRILL BIT, IF NEEDED
FLAT BLADE SCREWDRIVER
SPIRIT LEVEL OR PLUMB BOB AND LINE OPTIONAL—
THERMOSTAT DOES NOT NEED TO BE LEVEL TO WORK PROPERLY
Page view 0
1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - YOUR THERMOSTAT REPLACES

Installation Instructions forHeating & Air ConditioningMODEL 7757 Day Programmable ThermostatCONTENTSPreparations ...

Page 2 - MOUNTING AND WIRING

MOUNTING AND WIRINGTake care when securing and routing wires so they donot short to adjacent terminals or rear of thermostat.Personal injury and/or pr

Page 3 - Cooling System

CHECK THERMOSTAT OPERATIONwww.white-rodgers.com5RH24 VAC120 VACHotNeutralTHERMOSTATSYSTEMG WFigure 2. Typical wiring diagram forheat only, 3-wire, si

Page 4 - OPERATING FEATURES

CHECK THERMOSTAT OPERATIONCONTINUED FROM THIRD PAGEwww.white-rodgers.comBefore you begin programming your thermostat, you should befamiliar with its f

Page 5 - Configuration Menu

www.white-rodgers.comCONFIGURATION MENU6The configuration menu allows you to set certain thermostatoperating characteristics to your system or persona

Page 6 - Temperatures

www.white-rodgers.comPERIOD 1Time Temp Time TempHeating/Cooling Schedule PlanMonTuesWedThurFriSatSunHEAT COOLPERIOD 2Time Temp Time TempHEAT COOLPERIO

Page 7 - Check your programming

www.white-rodgers.comIf you are programming your thermostat for the first time, and youwant programming for all days of the week to be the same asMond

Page 8 - CONTINUED FROM SEVENTH PAGE

Symptom Possible Cause Corrective ActionNo Heat (continued) 5. Heating system requires service or Diagonistic: Set System Switch to Heat and raisether

Comments to this Manuals

No comments