White Rodgers 1687-9 Refrigeration Temperature Controls Installation Manual

Browse online or download Installation Manual for Fridge-freezers White Rodgers 1687-9 Refrigeration Temperature Controls. White Rodgers 1687-9 Refrigeration Temperature Controls Installation Instructions User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
To prevent electrical shock and/or equipment
damage, disconnect electric power to system at
main fuse or circuit breaker box until installation
is complete.
Label all wires prior to disconnection when ser-
vicing controls. Wiring errors can cause improper
and dangerous operation.
Following installation or replacement, follow
appliance manufacturers’ recommended instal-
lation/service instructions to insure proper
operation.
WHITE-RODGERS DIVISION
EMERSON ELECTRIC CO.
9797 REAVIS RD., ST. LOUIS, MO. 63123-5398
(314) 577-1300, FAX (314) 577-1517
9999 HWY. 48, MARKHAM, ONT. L3P 3J3
(905) 475-4653, FAX (905) 475-4625
Printed in U.S.A.
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
DESCRIPTION
TEMPERATURE CONTROL
SPDT Remote Bulb
INSTALLATION INSTRUCTIONS
INSTALLATION
The switch mechanism of this control may be mounted in
any location, provided that the temperature and humidity
of the air in which it is located do not cause a condensation
on the switch parts.
The sensitive element, or “bulb”, should be located in the
average temperature of the controlled area.
Capillary tubing should be led over a path that protects it
from damage from blows, cuts, etc., and should be
installed without kinking or twisting. The tubing should be
attached to some surface at frequent intervals along its
length, and should not hang loosely. Excess tubing should
be coiled and secured at a convenient protected location
close to the switch mechanism.
The bulb should be handled with reasonable care, as a
dent or sharp bend may change the calibration and cause
the control to cycle at a temperature different from the dial
setting.
PRECAUTIONS
THIS CONTROL MUST BE INSTALLED BY A QUALI-
FIED INSTALLER.
All wiring must conform to local and national electrical
codes and ordinances.
This control is a precision instrument, and should be
handled carefully. Rough handling or distorting compo-
nents could cause the control to malfunction.
This control has been accurately calibrated at the factory.
Any attempt to calibrate this control will void the White-
Rodgers warranty.
Do not use on circuits exceeding specified volt-
ages. Higher voltages will damage control and
could cause shock or fire hazard.
If in doubt about whether your wiring is millivolt,
low or line voltage, have it inspected by a quali-
fied heating and air conditioning contractor or a
licensed electrician.
This control is designed for use on equipment that re-
quires a closed circuit for both rise and fall in temperature.
The single pole, double throw switch action offers both
open-on-rise terminals as well as close-on-rise terminals.
WHITE-RODGERS
Operator: Save these instructions for future use!
PART NO. 37-1637C
Replaces 37-1637B
9722
This control has capillary tubing between the temperature
sensitive bulb and the switch mechanism, permitting the
switch mechanism to be mounted at any convenient
location while the temperature sensitive bulb is located in
the fluid or medium being controlled.
CAUTION
!
WARNING
!
Page view 0
1 2 3 4 5 6

Summary of Contents

Page 1 - WHITE-RODGERS

To prevent electrical shock and/or equipmentdamage, disconnect electric power to system atmain fuse or circuit breaker box until installationis comple

Page 2 - SETTING THE DIAL

2INSTALLATION AS AN OUTDOOR BULBWhen used as a changeover control or outdoor thermo-stat, the bulb of this control should be located to measurethe act

Page 3

Imprimé aux États-UnisIL FAUT LIRE ET SUIVRE SOIGNEUSEMENT TOUTES CES INSTRUCTIONSAVANT D’INSTALLER OU D’UTILISER CETTE COMMANDE POUR ÉVITERDES BLESSU

Page 4 - RÉGLAGE DU CADRAN

2INSTALLATION COMME BULBE EXTÉRIEURLorsqu’il est utilisé comme commande de commutationou thermostat extérieur, le bulbe de cette commande doitêtre pla

Page 5

WHITE-RODGERS DIVISIONEMERSON ELECTRIC CO.9797 REAVIS RD., ST. LOUIS, MO. 63123-5398(314) 577-1300, FAX (314) 577-15179999 HWY. 48, MARKHAM, ONT. L3P

Page 6 - AJUSTE DEL DIAL

2INSTALACION COMO UNA BOMBILLA DE AFUERACuando se usa como un control de cambio o como untermostato de afuera, la bombilla de este control tieneque qu

Comments to this Manuals

No comments