White-rodgers Thermostat 1F78 User Manual download pdf

CONTENTS

Preparations .................................................. 1

Thermostat Details ........................................ 1

Removing Old Thermostat ............................. 1

Mounting and Wiring ...................................... 2

Check Thermostat Operation ......................... 3

Speciﬁcations ................................................ 5

Troubleshooting ............................................. 5

PREPARATIONS

THERMOSTAT DETAILS

REMOVING OLD THERMOSTAT

Before removing wires from old thermostat’s switching subbase, label

each wire with the terminal designation it was removed from.

1. Remove Old Thermostat: A standard heat/cool thermostat

consists of three basic parts:

a. The cover, which may be either a snap-on or hinge type.

b. The base, which is removed by loosening all captive screws.

c. The switching subbase, which is removed by unscrewing the

mounting screws that hold it on the wall or adaptor plate.

2. Shut off electricity at the main fuse box until installation is com-

plete. Ensure that electrical power is disconnected.

3. Remove the front cover of the old thermostat. With wires still

attached, remove wall plate from the wall. If the old thermostat

has a wall mounting plate, remove the thermostat and the wall

mounting plate as an assembly.

4. Identify each wire attached to the old thermostat using the

labels enclosed with the new thermostat.

5. Disconnect the wires from the old thermostat one at a time. DO

NOT LET WIRES FALL BACK INTO THE WALL.

6. Install new thermostat using the following procedures.

To prevent electrical shock and/or equipment damage,

disconnect electrical power to the system at the main fuse

or circuit breaker until installation is complete.

PART NO. 37-6599B

Replaces 37-6599A

1026

Failure to follow and read all instructions carefully

before installing or operating this control could cause

personal injury and/or property damage

Assemble tools required as shown below.

WIRE CUTTER/STRIPPER

Base

Back of

Thermostat Body

RC GRH

YO B

W904

W905

Mounting

Hole

Mounting

Hole

Figure 1. Thermostat

W904 - clip for Celcius display

W905 - clip for hydronic system

NOTE: Earlier models refer to 37-7006 for jumper locations.

HAND OR POWER

DRILL WITH 3/16 INCH

DRILL BIT, IF NEEDED

FLAT BLADE SCREWDRIVER

Installation Instructions for

Heating & Air Conditioning

1E78

Non-Programmable Thermostat

YOUR THERMOSTAT REPLACES

Typical System Compatibility Chart 1E78

Standard Heat Only Two Wire Gas or Oil Fired Systems (24 volt) Yes

Electronic Ignition Heat Only Two Wire Systems (24 volt) Yes

Electronic Ignition Heat Only Gas or Oil Fired Systems (24 volt) Yes

Standard Heat/Cool Systems (24 volt) Yes

Heat/Cool Systems Electric Heat (24 volt) Yes

Heat Only Electric Heat Systems (24 volt) Yes

Cool Only Systems (24 volt) Yes

Heat Pump Systems (No Aux. or Emergency Heat) Yes

Hot Water Zone Heat Only (Two Wire) Systems Yes

Hot Water Zone Heat Only (Three Wire) Systems No

Line Voltage Heating or Baseboard 110/240 Volt Systems No

Millivolt Systems Floor or Wall Furnaces Yes

12 VDC Mobile Home Application Yes

Multistage Systems No

Systems Exceeding 30VAC, 1.5 Amp No

CAUTION

www.white-rodgers.com

www.emersonclimate.com

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - YOUR THERMOSTAT REPLACES

CONTENTSPreparations ... 1Thermostat Details ... 1Removing Old The

Page 2 - CONTINUED FROM FIRST PAGE

www.white-rodgers.com 4 MOUNTING AND WIRINGATTENTION! This product does not contain mercury. However, this product may replace a unit which contain

Page 3 - MOUNTING AND WIRING

www.white-rodgers.comNOTETo prevent static discharge problems, touch side of thermostat to release static build-up before touching any keys.5 CHECK T

Page 4

www.white-rodgers.comBefore you begin using your thermostat, you should be familiar with its features and with the display and the location and operat

Page 5 - TROUBLESHOOTING

www.white-rodgers.comELECTRICAL DATAElectrical Rating: 0 to 30 VAC 50/60 Hz. or D.C. 0.05 to 1.0 Amps (Load per terminal) 1.5 Amps Maximum Total

Page 6

www.white-rodgers.comSymptom Possible Cause Corrective ActionHeat, Cool or Fan Runs Constantly.Possible short in wiring.1. Possible short in thermosta

Page 7

www.white-rodgers.comNOTES

Page 8 - The Emerson logo is a

White-Rodgers is a division of Emerson Electric Co.The Emerson logo is a trademark and service mark of Emerson Electric Co.Homeowner Help Line: 1-80