6
On the Home Screen Display, press and hold the Menu button for approximately 5 seconds to enter the Comfort Interface Options
Menu button again for approximately 5
Menu. Press
Menu
Number
SS1
MS2
HP1
HP2
Press
or
to select options Description
01
MS2 SS121
MS2 = Multi-Stage conventional (no heat pump)
HP1 = Single compressor
HP2 = 2 compressor 2 speed compressor
SS1 = Single Stage conventional (no heat pump)
02
ELE Gas setting: Furnace controls blower
Elec setting: Comfort Interface controls blower
GAS
03
On
B
“O” Energizes O/B reversing valve terminal in cooling
“B” Energizes O/B reversing valve terminal in heating
04
1 or MS2
1 or HP2
05
CR Heat
21. If longer cycles are desired, set to SL.
Heat cycle rate: Fast, Med, and Slow
06
CR A/C
21
Cool cycle rate: Fast, Med, and Slow
07
CR Heat A/C
12)
Heat Pump cycle rate: Fast, Med, and Slow
08
SL
! 12)
Auxiliary cycle rate: Fast, Med, and Slow
09
CA
On ""#$
Enables active protection for the compressor. If the CA module sends alerts for condition
number #2, 3, 4, 6 or 7 the interface will cancel the call for cool to protect compressor. The
interface will blink setpoint and display “Call for Service” as well as the Comfort Alert numbers.
(see troubleshooting for Comfort Alert)
Will disable the active protection for the compressor
10
On %&
OFF
past 80%
Selecting On energizes the DHM terminal(s) and fan terminal (G) when humidity is above the
from the heating and cooling system.
Note:
Menu #8)
11
ID Hum
On %
OFF
On
setting. This feature is often used on steam systems and is independent from the call for heat or cool.
Note:
Menu #7)
12
CL
On '(
Will cause the interface to wait 5 minutes between cooling cycles. This is intended to help
protect the compressor from short cycling. Some newer compressors already have a time delay
built in and do not require this feature. Your compressor manufacturer can tell you if the lockout
feature is already present in their system. When the Comfort Interface compressor time delay
Will disable the feature
13
CO
On "*
CO ON
When compressor turns on (for a call for heat in heat pump or a call for cool) the fan will be
additional cooling from the system.
There will be no delay in fan operation
14 MS2
FA Heat
+
ON - Will enable this feature if you need to rapidly heat your home. Manually changing the
setpoint by 3 degrees or more will enable all stages of heat.
OFF - May not bring on secondary rapidly because it allows the Comfort Interface to compute
the optimum time to stage.
15 MS2
FA A/C
+
Will enable this feature if you need to rapidly cool your home. Manually changing the
setpoint by 3 degrees or more will enable all stages of cool.
May not bring on secondary rapidly because it allows the Comfort Interface to compute
the optimum time to stage.
CONFIGURE COMFORT INTERFACE FOR SYSTEM
Comments to this Manuals