White Rodgers NP100 User's Guide Page 1

NP100 Non-Programmable ThermostatInstallation Instructions & User GuideCongratulations on the purchase of your White-Rodgers™ thermostat!Save thes

16 173.4 Turn on power to your heating and cooling systemCongratulations! You have completed the basic setup of your new thermostat. It’s ready to use

18 19Default setting– no temperature adjustmentYour thermostat was accurately calibrated at the factory. However, if you would like the displayed temp

20 21Remember to turn off your heating / cooling system BEFORE resetting your thermostat. You will then have to go through a full initial setup descri

111ATTENTION: MERCURY NOTICEThis product does not contain mercury. However, this product may replace a product that contains mercury. Mercury and prod

2 3ABCPart 1 Before Getting Started1.1 Check package contentsOpen the package and verify that the following items are included:• Thermostat Wallplate

4 5CAUXGELYWRCRPart 2 Remove Old Thermostat and Install New ThermostatDo not disconnect wires from the old thermostat until you label all the wires ac

6 7✔ Ignore wire colors. There is no standard color code for thermostat wires.✔ Ignore existing wire labels, if they are present. ✔ Use the provided

8 9If the OLD thermostat’s terminal is wired into the wall and identifi ed by this letter……Then label its wire with this letter:You’ll need this inform

10 11B2.4 Match and connect wires2.4.1 Match each wire coming from the wall to its corresponding terminal, as shown in the illustration below. Inser

12 13System SwitchCool - air conditioningHeat - heatingOff - system turned offFan SwitchOn - fan always on for air circulationAuto - fan runs only whe

14 15Set SYSTEM switch to OFF position and then press both buttons simultaneously. You will be prompted to answer 5 “Options” questions, on page 15.A