White Rodgers NP100 User's Guide download pdf (Page 11)

18 19

Default setting

– no temperature adjustment

Your thermostat was accurately calibrated at the factory. However,

if you would like the displayed temperature to read higher or lower than

the actual temperature, you can adjust the displayed temperature

by +/- 4 degrees.

To adjust the actual temperature display:

1. Set the SYSTEM switch to OFF position.

2. Press both the

buttons simultaneously to advance through

the setup options until you reach a screen where “HI” or “LO”

is displayed.

3. Use the

buttons to adjust displayed temperature; from 4 HI

to 4 LO.

4. Move SYSTEM switch back to COOL or HEAT position when you

are ﬁ nished.

4.3 Adjust actual temperature display

Problem Possible Cause Action

Snowﬂ ake 5-minute lockout No action needed: should

icon blinking enabled to protect stop blinking after

compressor 5 minutes

No Heat, No Cool, Blown fuse / Replace fuse or reset

or No Fan tripped circuit breaker

breaker

Furnace power Turn switch to ON

switch to OFF

Furnace blower Replace door panel in

compartment door in proper position to

or panel loose or engage safety interlock

not properly or door switch

installed

Loose connection Tighten connections

to thermostat

or system

Low Batteries Replace batteries

Thermostat & The thermometer can be

Indoor adjusted +/- 4 degrees.

Thermometer See Temperature Display

Setting Disagree Adjustment in the

Conﬁ guration Menu section

Part 5 Troubleshooting Guide

1 2 ... 6 7 8 9 10 11 12

Comments to this Manuals

No comments

White Rodgers NP100 User's Guide Page 11

Comments to this Manuals

Related products and manuals for Thermostats White Rodgers NP100